Parker AO-015BNFI 尼克漢德空氣預濾器

Parker AO-015BNFI 尼克漢德空氣預濾器

先進的氣流技術，這是最高效節能的壓縮空氣過濾系統

   預過濾器和微型過濾器，具有內部持股量流失，易于安裝和節省初始投資成本

  事件監控（包括上大部分機型）向您發出警報高壓差和過濾器元件變化的需要

   房屋是完全腐蝕保護，并進行了10年的保修期

   這些模塊化的過濾器是高效率的答案，您的壓縮空氣過濾需求。過濾器殼體是Alocrom處理的鋁具有高品質的干

粉末環氧面漆。外殼在正常工作條件下，進行了10年的保修期。這些過濾器達到或超過預過濾器是最新的國際標

準ISO 8573.1空氣質量標準。深床褶疏油納米纖維顆粒去除1微米，包括水和油氣溶膠。最大剩余油氣溶膠含量

為0.5 ppm在70°F（的0.6 MG/M3在21°C）。微過濾床深褶疏油的納米纖維交付下降到0.1微米，包括水和油

氣溶膠粒子去除。的最大剩余油氣溶膠含量是0.1 ppm在70°F（21°C時為0.01 MG/M3）。活性炭吸附氣體，

氣態烴和氣味過濾器使用活性炭深床元素，墨盒也提高剩余油的去除在組合使用時的微型過濾器。最大殘留油蒸汽

的含量為0.003 ppm在70°F（的0.003 MG/M3在21°C）。使用可選的安裝夾具串聯安裝在相鄰的過濾器。還安

裝夾子作為壁掛式安裝支架，以盡量減少相關聯的硬件的功能。

    Advanced airflow technology makes this the most energy efficient compressed air filtration system available

    Prefilters and microfilters feature an internal float drain that eases installation and saves initial cost

   Incident monitor (included on most models) alerts you to high differential pressure and need for filter element change

   Housing is fully corrosion protected and carries a 10-year warranty

   These modular filters are the high-efficiency answer to your compressed air filtration needs. The filter housing is Alocrom-treated aluminum with a high-quality dry powder epoxy finish. Housings carry a 10-year warranty under normal operating conditions. These filters meet or exceed the latest International ISO 8573.1 air quality standard.
   Prefilters are deep bed pleated oleophobic nanofiber delivering particle removal down to 1 micron—including water and oil aerosols. Maximum remaining oil aerosol content is 0.5 ppm at 70°F (0.6 mg/m3 at 21°C).
  Microfilters are deep bed pleated oleophobic nanofiber delivering particle removal down to 0.1 micron—including water and oil aerosols. Maximum remaining oil aerosol content is 0.1 ppm at 70°F (0.01 mg/m3 at 21°C).
  Activated Carbon Filters use a deep-bed activated carbon element to adsorb vapors, gaseous hydrocarbons, and odors; cartridges also enhance residual oil removal when used in combination with microfilters. Maximum remaining oil vapor content is 0.003 ppm at 70°F (0.003 mg/m3 at 21°C).
  Use optional mounting clamps to join adjacent filters mounted in series. Mounting clamp also functions as a wall-mounting bracket to minimize associated hardware.