TQC Concrete Moisture Meter 混凝土水分測定儀
該TQC混凝土水分測定儀是一種測量混凝土的非破壞性水分測定儀。通過測量電阻抗的裝置,混凝土中的水分含量可以很容易地通過按壓在混凝土表面上的儀器來確定。
The TQC Concrete Moisture Meter is a non-destructive moisture meter for concrete. By means of measuring the electrical impedance the moisture content of concrete can easily be determined by just pressing the instrument against the concrete surface.
電阻抗是通過產生一個低頻電場,在儀器底部8個電極之間測量。根據含水率測量值是幾厘米的深度。四個尺度允許靈活的使用該
儀器作為一個準確的測量設備或者只是作為一個探測器發現水分痕跡或泄漏:
The electrical impedance is measured through generating a low frequency electric field between 8 electrodes at the bottom of the instrument. Depending on the moisture content the measurements are made to a depth of several centimeters. Four scales allow flexible use of the instrument as an accurate measuring device or just as a detector to find moisture traces or leakage:
混凝土0-6%H 2 O
混凝土規模可以僅用于混凝土表面上使用。它示出了純水的重量包含于測試物體自重的關系。規模范圍變化介于0和6%,至6%時混
凝土中的水分可能是最大的。獲得的結果不應被濕氣排放或其他濕度測量方法混淆.
Concrete 0-6% H2O
Concrete scale may be used only for concrete surfaces. It shows the relation between weight of pure water contained in the tested material with its dry weight. The scale range varies between 0 and 6% as 6% is about maximal physically possible content of water in the concrete. The obtained results should not be confused with moisture emission or any other moisture measurement methods.
碳化物方法0-4%H 2 O
混凝土刻度跟家碳化物方法顯示混凝土濕度。
Carbide Method 0-4% H2O
Concrete scale shows concrete moisture according to the carbide method.
相對比例0-100%
相對比例可使用于比較各種材料的水分含量。得到的結果不應該被解釋為測試表面水的百分含量。結果與相對濕度之間沒有線性相
關。比例應只用作比較。比例可用于直接接觸無層/無覆蓋物的純混凝土表面。
Relative Scale 0-100%
Relative scale may be used in moisture level comparison of various materials. Obtained results should not be interpreted as percentage content of water in tested surfaces.There is no linear correlation between the outcomes and relative humidity. The scale should be used only as comparison technique. Scale may be used on the surfaces where direct contact with pure concrete is impossible because of some layer/covering.
?
15. Scale 0.3 - 15.3米 15. Scale 0.3 - 15.3m
15. Scale同相對比例類似,范圍在0.3-15.3
15. Scale works in a similar way as the Relative scale and can be used alongside meters with the same scale which ranges between 0.3 and 15.3.
使用方法:
壓在被測表面的儀表,直到所有的彈簧電極完全受阻。
注意:不要過于強??烈按壓設備,因為這可能會損壞電極。
注意:測量時手指不能接觸的感測板和電極
測量時測量計應放在中間,建議重復測量相鄰的幾個點以防有分布不均。如果測量值發生變化,僅用最高結果。
關閉儀表按ON / HOLD鍵2秒左右。
Press the meter against the tested surface until all spring electrodes are completely blocked.
Caution:Do not press the device too intensely as this may harm the electrodes.
Caution:Fingers SHOULD NOT touch the sensor plate and electrodes while measuring.
The meter should be held in the middle while measuring (as shown in the picture) It is recommended to repeat the measurement in a few points situated next to each other as moisture has a tendency of uneven distribution. If the measurements vary, only the highest outcomes should be used.
To switch off the meter press ON/HOLD button for around 2 seconds.
?
特殊護理:
盡管設計堅固,但這是精密儀器。不要摔或者或敲它。
使用后,要清洗儀器。
用干的軟布清潔儀器。不要用任何器械清洗儀器,如鋼絲刷或砂紙。就像使用腐蝕性清潔劑一樣,這可能會造成永久性的損害。
不要使用壓縮空氣吹洗儀器。
不用時始終保持儀器清潔。
Special Care:
Though robust in design, this instrument is precison-machined. Never drop it or knock it over.
Always clean the instrument after use.
Clean the instrument using a soft dry cloth. Never clean the instrument by any mechanical means
such as a wire brush or abrasive paper. Just like the use of aggressive cleaning agents, this may
cause permanent damage.
Do not use compressed air to clean the instrument.
Always keep the instrument in its case when not in use.
?
技術參數
外形尺寸: 147 X 89毫米X 33毫米
電源: 2節AA電池
平均工作時間/電池套裝: 20小時
顯示方式: 單色128×64像素,尺寸61毫米x 33毫米,帶背光
工作溫度范圍: 5°C至40°C
精度: ±0.5%
尺度: 水泥,電石法,相對比例,15.Scale
Technical Data
Dimensions: 147 x 89 x 33mm
Power Supply: 2xAA batteries
Avg Working Time/Battery Set: 20 hours
Display: monochrome 128 x 64 pixels; size 61 x 33mm with backlight
Operating Temperature Range: 5°C to 40°C
Accuracy: ±0.5%
Scales: Concrete, Carbide Method, Relative Scale, 15. Scale
?
?
?
?
?
?
購買咨詢
(已有0條咨詢)商品評論
(已有0條評論)購買流程
1.購買產品:點擊“立即購買”→填寫產品數量、聯系方式并提交→會員顧問訂單處理→合同簽訂。
2.咨詢產品:請聯系會員顧問或致電會員客服電話。
3.如果您還不是我們的會員,請先注冊。
4.最小起訂數量:1 ,進口產品貨期,請跟產品擔當聯系!
品牌擔當:
投訴電話:17717909117
聯系方式: 電話:021-52069907 分機 或撥0轉總機,傳真:010-52060857
維修流程
- 1、技術溝通,初步判斷問題電話,與客戶進行初步溝通、了解并初步判斷儀器所出現的故障問題。
- 2、簽訂維修協議由我公司向客戶發送儀器維修協議,客戶需如實填寫內容并回傳以便我司對儀器做進一步判斷。
- 3、客戶郵寄儀器客戶可按照我司地址郵寄儀器,并將快遞單拍照發送至您的專屬客服進行備案。
- 4、詳細診斷機器故障我司收到郵寄儀器后會對郵寄的儀器進行拍照并開箱檢驗,對儀器做進一步故障判斷。
- 5、支付維修費用如客戶儀器在保修期內,我司不收取任何維修費,如客戶儀器在保修期外,我司會適當收取維修費。
- 6、郵寄儀器給客戶我司將維修好的儀器按客戶地址進行拍照并郵寄,自此雖維修協議終止,但我司將提供終身免費答疑及技術指導。
Testo 340 煙氣分析儀 | Testo350 煙氣分析儀 | PMS塵埃粒子計數器 | TSI塵埃粒子計數器 | Lighthouse塵埃粒子計數器 | Metone塵埃粒子計數器 |
HACH塵埃粒子計數器 | TSI氣溶膠發生器 | ATI氣溶膠發生器 | Palas氣溶膠發生器 | Topas氣溶膠發生器 | Palas靜電中和器 |
Topas靜電中和器 | Grimm粒徑譜儀 | TSI粒徑譜儀 | Topas粒徑譜儀 | Palas粒徑譜儀 | TSI掃描電遷移率粒徑譜儀 |
HTV 甲醛檢測儀 | HTV-M甲醛檢測儀 | TVOC 檢測儀維修 | Grimm掃描電遷移率粒徑譜儀 | Palas掃描電遷移率粒徑譜儀 | Brechtel掃描電遷移率粒徑譜儀 |
TSI 8530粉塵儀 | TSI 8532粉塵儀 | TSI 8533粉塵儀 | Rad7 氡檢測儀 | TSI 8534粉塵儀 | Thermo PDR-1500粉塵儀 |
ATI 2i光度計 | ATI氣溶膠稀釋器 | 風量罩 | 風速儀 | 空氣品質檢測儀 | EN779測試臺改造 |
Dustmate 粉塵儀 | TSI 8108大顆粒氣溶膠發生器 | TSI 3450單分散氣溶膠發生器 | 車身氣密性檢測設備 | 風管漏風量測試設備 | 凝聚核粒子計數器校準裝置 |
粒子計數器校準裝置 | 更多型號請咨詢客服19mro@19mro.com |
相關商品