RWS 屋頂和墻面濕度掃描儀 MO-952203

RWS及外墻外保溫系統

RWS & EIFS

對屋頂和外墻外保溫建筑圍護結構的非破壞性評估水分

追蹤泄漏到防水隔膜回到源

速度快，操作方便

即時讀數清晰

“保持”功能便于輕松記錄讀數

輕巧的手持和電池供電

For non-destructive moisture evaluation of Roofs and EIFS Building Envelope

For tracing leaks into the waterproofing membrane back to the source

Fast and easy to operate

Instant clear readings

“Hold” function facilitates ease of recording readings

Lightweight hand held and battery operated

RWS的具有雙操作模式的外墻外保溫和屋面。每種模式有2個范圍的靈敏度為深，低滲透敏感性，使屋頂的掃描和外墻外保溫系統，具有信號穿透，從表面高達約4“（100毫米）。

該RWS是一個電子手持式濕度掃描儀和探測器工作在電阻抗原理。帶阻抗測量，無害信號從電極在儀器的底部進深區域的被測厚度發送。這些信號測量電阻抗的變化，并譯成了一個相對含水率讀數瞬間就清楚了大型模擬表盤顯示。讀數是即時的和連續的。該RWS還裝有這聽起來在高讀數發聲裝置。RWS的給予評價，并進行評估的水分大部分纖維的必要條件的重要信息加強外墻外保溫墻面系統，屋面系統，如建立起來的，非導電單層，修改和泡沫屋面價格低廉，無并發癥。

對于外墻外保溫系統，RWS的已特別制定了耐候涂層或覆蓋物內的檢測，定位和多余的水分跟蹤幫助，并深入到絕緣和基板檢測多余的水分在護套和外墻外保溫系統的木天花板高度。用于屋頂它將檢測interply水分，在絕緣材料中多余的水分和濕氣中或上的非導電屋頂甲板。

它是容易和快速的使用，重量輕，攜帶，并且可以用一只手來操作。經檢測和定位的多余水分的領域RWS可以有很大的好處在追查這個水分回到它的入口點或來源。The RWS has dual operating modes for EIFS and Roofing. Each of these modes has 2 ranges of sensitivity for both deep and low penetration sensitivity, enabling the scanning of Roofing, and EIFS, with a signal penetration ranging from the surface up to approximately 4” (100mm).

The RWS is an electronic hand-held Moisture Scanner and Detector working on the principle of electrical impedance. With impedance measurement, harmless signals are transmitted from the electrodes at the base of the instrument deep into the thickness of the area under test. These signals measure the change in electrical impedance which is translated into a relative moisture content reading and instantly displayed on the clear large analog dial. Readings are instant and continuous. The RWS is also fitted with an audible device which sounds at high readings. The RWS gives vital information necessary to evaluate and carry out moisture assessment on the condition of most fiber reinforced EIFS wall cladding systems, roofing systems such as built up, non-conductive single ply, modified and foam roofing at an affordable cost and without complications.

For EIFS, the RWS has been especially developed to aid in the detection, location and tracing of excess moisture within the weatherproofing coatings or coverings, and deep into the insulation and substrate to detect excess moisture in the sheathing and the wood studding of EIFS systems. For Roofing it will detect interply moisture, excess moisture in the insulation material, and moisture in or on non-conductive roof decks.

It is easy and fast to use, light to carry and can be operated with one hand. Having detected and located the areas of excess moisture the RWS can be of great benefit in tracing this moisture back to its point of ingress or source.

技術參考

外形尺寸： 4.75“×11”×3“（125毫米x275毫米×75）

重量： 4磅。（1.8公斤）

電源： 一個9伏電池

靈敏度： 四個范圍：外墻外保溫系統模式與高和低靈敏度高和低靈敏度屋面模式

附件： 皮套，使用伸縮手柄上唯一屋頂

局限性： 屋頂：三元乙丙橡膠，丁基橡膠屋面等導電屋面

外墻外保溫系統： 超硬粉刷，電線板條或鐵絲網加固完成

RWS檢測套裝-包含：（1）RWS，（2）專業數字引腳型電阻計瓦特/內置針，（3）手持電極瓦特/ 7“絕緣針，（4）伸縮手柄為RWS屋面上使用只是，（5）模具切割泡沫內襯手提箱帶切口的紅外溫度計，數字溫濕度計 MO-952213   價格：20750元

Technical Data

Dimensions: 4.75” x 11” x 3” (125mm x 275mm x 75mm)

Weight: 4 lbs. (1.8kg)

Power Supply: One 9 volt battery

Sensitivity: Four ranges: EIFS Mode with high and low sensitivity Roofing Mode with high and low sensitivity

Accessories: Leather carrying case, Telescopic handle for use on roofing only

Limitations: Roofing: EPDM, Butyl rubber roofing and other conductive roofing

EIFS: Hard Coat Stucco, wire lath or wire mesh reinforced finishes

?