Directions for Use Place the cartridge into the

3M EPX Applicator and clip into position.

Remove the resealable cap.Expel a small quantity of

adhesive and ensure both components flow freely.

Attach correct mixer nozzle (this should have 20 or

more elements).Dispense the adhesive as

required.

When finished either leave the nozzle in place and

store, or remove the nozzle,wipe clean the tip, and

replace cap.

To re-start after storage remove the old nozzle with

cured adhesive and re-fit a new nozzle, or remove the

cap and fit a new nozzle.

Surface Preparation:The degree of surface preparation depends on the

bond strength required and the environment likely to be

encountered by the bonded structure.

For most applications solvent wiping with 3M

VHB? Surface Cleaner,followed by abrasion with

3M Scotchbrite? 7447,followed by a further solvent

wipe until clean, will give good performance (except

for acetal, polyethylene and polypropylene and some

other low surface energy materials). The same

process will also give good adhesion to metal surfaces.

Where humid environments are likely to be encountered

we recommend additional priming with 3M ScotchWeld

1945B/A for metal surfaces.

Clean Up Clean-Up:

Excess uncured adhesive can be removed with the

following products:3M VHB Surface Cleaner

(mild alcohol based cleaner)

3M Scotch-Grip Solvent No2. (Ketone blend)

3M Industrial Cleaner (Aerosol).