OPERATION:

? The meter is supplied complete with a 9V battery.

Slide off the battery compartment cover on the back of the meter. Install the battery into the battery clip connector while observing polarity.

? Connect the probe to the meter securely by aligning the pins with the plug in.

? Make sure that the meter has been calibrated before taking any measurements (see Calibration Procedure).

? Immerse the tip (4 cm) of the EC/TDS probe into the sample. If possible use plastic beakers or containers to minimize any EMC interference.

? Turn the instrument on by pressing the ON/OFF key.

? Wait for the temperature sensor to reach the thermal equilibrium before taking any measurements.

? After use, the instrument should be switched off and the probe should be cleaned and dried. Whenever needed, use alcohol for better cleaning.